濟南誠耐金屬制品有限公司

濟南誠耐金屬制品有限公司

不斷發展技術力量、完善的設計服務團隊,真誠為您提供的服務

咨詢熱線
于經理15194166167
15990909037

聯系我們

企業名稱:濟南誠耐金屬制品有限公司

聯系人:于經理

電話: 15990909037

電話: 15194166167

地址:山東省濟南市歷城區小清河南路8288號

當前位置:首頁 »資訊中心 » 常見問題安裝門套有縫隙?教你一招

安裝門套有縫隙?教你一招

來源:http://m.duobimai.com/ 瀏覽:0發表時間:2022-12-19
我們在室內裝修安裝門套時,經常會發現門套與墻面之間,會有縫隙,那么這種縫隙該怎么處理呢?
When we install door jambs in the interior decoration, we often find gaps between the door jambs and the wall. How to deal with such gaps?
室內裝修門套裝好后與墻面有縫隙該怎么辦?
What should I do if there is a gap between the interior decoration door and the wall after it is installed?
要排除你家門洞兩邊的墻是否不平整,門套與墻面縫隙平均在2.公分及以內的,都是正常的,這樣可以調整門的安裝誤差。平均縫隙超過2.5公分就是測量尺寸有誤差是不正常的!
First, it should be ruled out whether the walls on both sides of your door opening are uneven. It is normal that the gap between the door jamb and the wall is 2 cm or less on average. This can adjust the installation error of the door. If the average gap is more than 2.5 cm, it is abnormal to measure the size with error!
處理方法;縫隙大小看墻體垂直程度,這個縫隙可以打玻璃膠,也可以油漆批膩子來補就可以了,否則門的安裝就不堅固。會出現晃動,時間長了就會導致開裂等隱患!
Treatment method; The size of the gap depends on the verticality of the wall. The gap can be filled with glass glue or paint and putty, otherwise the door will not be firmly installed. There will be shaking, and a long time will lead to cracks and other potential safety hazards!

如果縫隙很大,那就是墻體不平整!可以選擇在縫隙處填磚或者水泥漿,這樣才能保證墻體與門框縫隙結實不透。這一般是安裝完后的補救辦法,就是在測量時把握好尺寸,盡量保持縫隙在1-2公分以內!墻面不平是很常見,所以我們在裝修時,一定要提前考慮掉,否則會給后面的施工帶來影響
If the gap is large, the wall is uneven! The joints can be filled with bricks or cement mortar to ensure that the joints between the wall and the door frame are firm and impermeable. This is generally a remedy after installation, that is, when measuring, grasp the size and try to keep the gap within 1-2 cm! Uneven walls are very common, so we must consider to solve them in advance when decorating, otherwise it will affect the later construction
門框和門的尺寸不匹配,或門框與墻之間安裝處理不當,很可能會出現縫隙??p隙比較小的業主可以自己在門下面貼橡膠條來處理,如果門底部縫隙太大建議找裝修師傅更換。
The size of the door frame and the door does not match, or the installation between the door frame and the wall is improper, which may lead to gaps. Owners with small gaps can stick rubber strips under the door to deal with the problem. If the gap at the bottom of the door is too large, it is recommended to find a decorator to replace it.
總結;安裝門后一般都是會有縫隙,只要不超過正常的標準,打玻璃膠油漆批膩子都可以修補好!
Summary; After the door is installed, there is usually a gap. As long as it does not exceed the normal standard, it can be repaired with glass glue, paint and putty!
以上就是為大家介紹的有關濟南鋁合金門套的詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務http://m.duobimai.com
The above is a detailed introduction to Jinan aluminum alloy door pocket, and I hope it will be helpful to you. If you have any questions, please contact us. We will provide services for you with our attitude http://m.duobimai.com